Speaker wire for Yamaha surround sound.? - how to get surround yamaha rx-v363
I bought a Yamaha surround sound system and everything is fine until I add my voice to the speakers. There is a large thread. The manual says basically to connect it, so now I tell myself that I must cut the wire. the right tone? If so any tips for cutting my own speaker cable
Friday, February 5, 2010
How To Get Surround Yamaha Rx-v363 Speaker Wire For Yamaha Surround Sound.?
Subscribe to:
Post Comments (Atom)
2 comments:
Stripping is preferably not necessary to cut the wire to length, then remove about 1 / 2 inch insulation from each site - Make sure the cable is not connected to anything in the cup. After removing the insulation, roll / twist the wire ends if it is solid and has no free drivers - who could cause problems. Make sure that the cable is connected with the correct polarity - black connector on the receiver to the black terminal on the loudspeaker and red to red.
Stripping:
http://www.google.com/products/catalog?h ...
Poster above is correct.
Ensure IMPORTANT: You are, there is no son of the prominent copper. Over time, causing a short circuit and may damage your electronic equipment. Cut a meter speaker cables and the practice of obtaining enough money to build relationships. Radio Shack did not have expensive help. After a little practice before you in reality.
Cut cable to length and 1-2 feet loose. You may have to cut the ends of each year or, if the copper is oxidized.
Take your time. Make a clean work clothing wire.
Radio Shack also sells bananas and 306 and 308 models that are working to make it easier to clean. The plugs are two fantastic for preventing short circuits by solid plastic partition. However, buying a pair and bring them home when the distance of the terminals are not standardized. That's where the bananas come into play only
Enjoy your new system.
Post a Comment